U Turn-Harness

¥800  (Tax not included)

U Turn-Harness is a part to light off indicator, when airbag of driving side put off.
A car that has used concavity at airbag coupler in vehicle side should be used a convex type U Turn-Harness terminal and a car that has used convex should be used a concavity type U Turn-Harness terminal.

 

Attention

・ You can’t use it in way above.
・ Some car doesn’t light off airbag indicator, because of error of the car.

There is a connector on the wiring from the spiral cable to the SRS airbag module, so the connector on the side of the spiral cable uses a male terminal.

Since there is a connector on the wiring from the spiral cable to the SRS airbag module, the connector on the side of the spiral cable uses a female terminal.

There is no connector in the wiring from the spiral cable to the SRS airbag module, and it is a type that is directly inserted in the center of the back side of the SRS airbag module.

 

※ Please do not bend the terminal only once. Repeated folding several times, it may break.

* For all types, please be sure to fix it so that there is no poor contact. Please use vinyl tape etc. if necessary. If there is a contact failure, the SRS warning light will be lit or flashing.

* The processed SRS airbag connector and the U-turn harness are not required to be pulled into the handle boss. Please store it so that it wraps around the inside of the boss cover around the boss and fix it with tape etc. so that noises will not come out.

* Depending on the current characteristics of your car, the warning light may turn on (blink) even if it is wired accurately. In this case, you may not be able to turn off unless you use a dealer etc. to diagnose. please note that.

Notice of price change

 

We will inform you that we will change the price of the item. Details are described in the guide here so please make an investigation.