worksbell

img

U Turn-Harness

Product Overview

U Turn-Harness

800 yen (excluding tax)

The "U-turn harness" is a component to turn off the warning light when the driver's airbag is removed.
Please use a male type U-turn harness if your vehicle has a female terminal on the vehicle side airbag coupler, or a female type U-turn harness if your vehicle has a male terminal.
NOTE
*This product cannot be used for purposes other than those mentioned above.
*Some vehicles may not turn off the airbag warning light due to vehicle error.

img

There is a connector in the wiring from the spiral cable to the SRS airbag module, so this is the type where the connector on the spiral cable side uses a male terminal.

img

There is a connector in the wiring from the spiral cable to the SRS airbag module, so this is the type where the connector on the spiral cable side uses a female terminal.

img

The wiring from the spiral cable to the SRS airbag module does not have a connector, but is plugged directly into the center of the back side of the SRS airbag module.

  • The terminals must be bent only once. Repeatedly bending the terminals several times may cause them to break.
  • Securely fix the terminals so that there is no poor contact. Use vinyl tape if necessary. If there is a poor contact, the SRS warning light will turn on or flash.
  • It is not necessary to insert the processed SRS airbag connector and U-turn harness into the handlebar boss. It should be stored in such a way that it is wrapped around the inner side of the boss cover and secured with tape or other means to prevent noise from coming out.
  • Due to the current characteristics of your car, the warning light may turn on (blink) even if the wiring is correct. In this case, it may not be possible to turn off the warning light without a diagnostic device at the dealer. Please be aware of this.

Related Items